文件名称:
菲律宾Globe(运营商)华为替换项目参数继承策略
开发工具:
文件大小: 230kb
下载次数: 0
上传时间: 2013-01-04
详细说明: "Connection with TMA (Tower Mounted Amplifier) 3GPP Specifications Conversational QoS Class Interactive QoS Class Integrity Protection Encryption ATM over E1T1 on Iub Interface ATM over Channelized STM-1/OC-3 on Iub Interface NACC Procedure Optimization MBSC Load Balancing MBSC Handover based on Load Enhancement IP-Based GSM and UMTS Co-Transmission on MBSC Side" UE Behaviors in Idle Mode ATT Attach/detach allowed indication Indicating whether attach/detach is allowed. NOT_ALLOWED indicates that MS cannot apply the IM SI attach/detach procedure. ALLOWED indicates that MS can apply the IMSI attach/detach procedure. It is valid only when [CN domain ID] is set as CS_DOMAIN. "ADD UCNDOMAIN " NOT_ALLOWED, ALLOWED Inter RNC Cell Update UE Behaviors in Idle Mode Qoffset1sn Qoffset1sn "Offset between the neighboring GSM cell and WCDMA cell. This specifies the offset of the measurement value of the neighboring GSM cell signal quality. This parameter is used for RSSI measurement. The offset is subtracted from the neighboring cell measurement value before cell reselection. In cell reselection algorithm, this parameter is used for moving the border of a cell. Content: During cell selection or resection, the larger the value of the parameter, the smaller the probability of selecting inter-RAT neighboring cells. The smaller the value of the parameter, the larger the probability of selecting inter-RAT neighboring cells. This parameter can be configured by the network planner according to reality. For details, refer to 3GPP TS 25.331. As for the impact on network performance: The larger the value of the parameter, the lower the probability of selecting neighboring cells. The smaller the value the parameter, the higher the probability of doing so." ADD U2GNCELL -50~50 Inter RNC Cell Update UE Behaviors in Idle Mode Qqualmin Min Quality Level "Minimum CPICH Ec/No for the neighboring cell on cell reselection. The neighboring cell can be involved in cell sorting for reselection only when its CPICH Ec/No is above this threshold. If this parameter is set to the same value as Qqualmin for the serving cell, Qqualmin is not contained in SIB11 or SIB12. In this case, the UE extracts the Qqualmin from SIB3. For details, see the 3GPP TS 25.331. According to the 3GPP TS 25.304, S criterion for cell reselection is defined as follows: Srxlev > 0 and Squal > 0 Here, Squal = Qqualmeas - Qqualmin Srxlev = Qrxlevmeas - Qrxlevmin - Pcompensation ""Qqualmeas"" refers to the measured CPICH Ec/No. ""Qrxlevmeas"" refers to the CPICH RSCP. ""Qrxlevmin"" refers to the minimum CPICH receive power in the current cell. Pcompensation = max(UE_TXPWR_MAX_RACH - P_MAX, 0) ""UE_TXPWR_MAX_RACH"", also named as ""MaxAllowedULTxPower"", refers to the maximum uplink transmit power when the UE accesses a cell. ""P_MAX"" refers to the maximum RF output power of the UE." "ADD UINTERFREQNCELL " -24~0 Inter RNC Cell Update UE Behaviors in Idle Mode Qrxlevmin Min RX Level Minimum CPICH RSCP for the neighboring cell on cell reselection. The neighboring cell can be involved in cell sorting for reselection only when its CPICH RSCP is above this threshold. If this parameter is set to the same value as Qrxlevmin for the serving cell, Qrxlevmin is not contained in SIB11 or SIB12. In this case, the UE extracts the Qrxlevmin from SIB3. For details, see the 3GPP TS 25.331. Qrxlevmin should be set to a proper value, to match Qqualmin. "ADD UINTERFREQNCELL " -58~-13 "Intra RNC Cell Update Inter RNC Cell Update" UE Behaviors in Idle Mode Qrxlevmin Min RX Level "Minimum RX level of the GSM cell. Before the UE camps on the cell, take the measurement of the signal quality in the cell. If the quality is better than this parameter, this indicates that the cell can obtain better QoS and the UE is allowed to camp on this cell. Otherwise, the UE cannot obtain good QoS in this cell and does not camp on the cell." ADD U2GNCELL -58~-13 "Intra RNC Cell Update Inter RNC Cell Update" UE Behaviors in Idle Mode Qqualmin Min quality level The minimum required quality threshold corresponding to CPICH Ec/No. The UE can camp on the cell only when the measured CPICH Ec/No is greater than the value of this parameter. The higher the parameter value is, the more difficult it is for the UE to reside in the cell. The lower parameter value is, the easier it is for the UE to reside in the cell, but it is possible that the UE cannot receive the system messages that are sent through the PCCPCH. For detailed information, refer to the 3GPP TS 25.304. "ADD UCELLSELRESEL " -24~0 "Intra RNC Cell Update Inter RNC Cell Update" UE Behaviors in Idle Mode Qrxlevmin Min Rx level The minimum required RX threshold corresponding to CPICH RSCP. The UE can camp on the cell only when the measured CPICH RSCP is greater than the value of this parameter. The setting of Qrxlevmin should be related to Qqualmin. The higher the parameter is, the more difficult it is for the UE to reside in the cell. The lower parameter is, the easier it is for the UE to reside in the cell, but it is possible that the UE cannot receive the system messages that are sent through the PCCPCH. For detailed information, refer to 3GPP TS 25.331 10.3.2.3. "ADD UCELLSELRESEL " -58~-13 ...展开收缩
(系统自动生成,下载前可以参看下载内容)
下载文件列表
相关说明
- 本站资源为会员上传分享交流与学习,如有侵犯您的权益,请联系我们删除.
- 本站是交换下载平台,提供交流渠道,下载内容来自于网络,除下载问题外,其它问题请自行百度。
- 本站已设置防盗链,请勿用迅雷、QQ旋风等多线程下载软件下载资源,下载后用WinRAR最新版进行解压.
- 如果您发现内容无法下载,请稍后再次尝试;或者到消费记录里找到下载记录反馈给我们.
- 下载后发现下载的内容跟说明不相乎,请到消费记录里找到下载记录反馈给我们,经确认后退回积分.
- 如下载前有疑问,可以通过点击"提供者"的名字,查看对方的联系方式,联系对方咨询.