文件名称:
Shigley-s-Mechanical-Engineering-Design
开发工具:
文件大小: 50mb
下载次数: 0
上传时间: 2016-02-16
详细说明： In the development of the basic stress equations for tension, compression, bending, and torsion, it was assumed that no geometric irregularities occurred in the member under consideration. But it is quite difficult to design a machine without permitting some changes in the cross sections of the members. Rotating shafts must have shoulders designed on them so that the bearings can be properly seated and so that they will take thrust loads; and the shafts must have key slots machined into them for securing pulleys and gears. A bol t has a head on one end and screw threads on the other end, both of which account for abrupt changes in the cross section. Other parts require holes, oil grooves, and notches of various kinds. Any discontinuity in a machine part alters the stress distribution in the neighborhood of the discontinuity so that the elementary stress equations no longer describe the state of stress in the part at these locations. Such discontinuities are called stress raisers, and the regions in which they occur are called areas of stress concentration. Stress concentrations can also arise from some irregularity not inherent in the member, such as tool marks, holes, notches, grooves, or threads. 1 in T 18 in Figure 3–28 The cross-section of a thin strip of steel subjected to a torsional moment T. bud29281_ch03_071-146.qxd 11/24/09 3:02PM Page 110 ntt 203:MHDQ196:bud29281:0073529281:bud29281_pagefiles: Load and Stress Analysis 111 A theoretical, or geometric, stress-concentration factor Kt or Kts is used to relate the actual maximum stress at the discontinuity to the nominal stress. The factors are defined by the equations K t = σ max σ0 K ts = τ max τ0 (3–48) where Kt is used for normal stresses and Kts for shear stresses. The nominal stress σ0 or τ0 is the stress calculated by using the elementary stress equations and the net area, or net cross section. Sometimes the gross cross section is used instead, and so it is always wise to double check the source of Kt or Kts before calculating the maximum stress. The stress-concentration factor depends for its value only on the geometry of the part. That is, the particular material used has no effect on the value of Kt. This is why it is called a theoretical stress-concentration factor ...展开收缩
(系统自动生成,下载前可以参看下载内容)
下载文件列表
相关说明
- 本站资源为会员上传分享交流与学习,如有侵犯您的权益,请联系我们删除.
- 本站是交换下载平台，提供交流渠道，下载内容来自于网络，除下载问题外，其它问题请自行百度。
- 本站已设置防盗链，请勿用迅雷、QQ旋风等多线程下载软件下载资源，下载后用WinRAR最新版进行解压.
- 如果您发现内容无法下载，请稍后再次尝试；或者到消费记录里找到下载记录反馈给我们.
- 下载后发现下载的内容跟说明不相乎，请到消费记录里找到下载记录反馈给我们，经确认后退回积分.
- 如下载前有疑问，可以通过点击"提供者"的名字，查看对方的联系方式，联系对方咨询.
