您好,欢迎光临本网站![请登录][注册会员]  
文件名称: Telemecanique Unity Pro的系统功能块库的参考手册(英文).pdf
  所属分类: 其它
  开发工具:
  文件大小: 1mb
  下载次数: 0
  上传时间: 2019-10-20
  提 供 者: weixin_********
 详细说明:Telemecanique Unity Pro的系统功能块库的参考手册(英文)pdf,Telemecanique Unity Pro的系统功能块库的参考手册(英文)Table of contents About the book Part General information 9 Introduction 9 Chapter1 Block types and their applications..…………….11 Introduction Block types 12 FFB Structu 13 EN and Eno 16 Chapter 2 Availability of the function block on different hardware platforms Introducti 23 Chapter 3 HALT: Stopping the program n25 Chapter 4 TCNTRL Triggering of tIMer type event processing 27 Chapter 5 MASKEVT: Global masking of events .31 Chapter 6 UNMASKEVT: Global unmasking of events........ 33 Part ll Hot stand By...∴.∴35 Introduction 35 Chapter 7 HSBY RD: Reading the hot standby command register 37 Chapter 8 HSBY ST: Reading the hot standby status register .... 41 Chapter 9 HSBYWR: Writing to the Hot Standby command register.∴∴∵∵ 45 Chapter 10 REV_XFER: Writing and reading the two Reverse-Transfer-Registers 49 Part Iv SFC Management...,............ 53 Introduction 53 Chapter 11 CLEARCHART: Reset all active steps 55 Chapter 12 FREEZECHART: Freeze sequence ,.59 Chapter 13 INITCHART: Reset all active steps and start sequence normall ■■■■ 63 Chapter 14 RESETSTEP: Reset a specific step in the sequence 67 Chapter 15 SETSTEP: Set a specific step in the sequence,..,... 69 Chapter16 SECCNTRL: SFC Contro|∴..∴∴71 Overview .,,71 Description..... 2 Parameter description 77 Part v Sysclock ,,,83 Introduction 83 Chapter 17 FREERUN: Free-running timer Chapter 18 PTC: Reading the stop date and code 87 Chapter 19 RRTC_DT: Reading the system date......,.... 89 Chapter 20 R_NTPC: Network real-time clock function 91 Chapter 21 SCHEDULE: Real-time clock function ..,....... 95 Chapter 22 WRTC_DT: Updating the system date.......... 99 Appendice 101 Introduction Appendix a System objects.....,...,......... 103 At a glance ..,103 System bit introduction 104 Description of system bits %so to %S7 105 Description of system bits %S15 to %S2 Description of system bits %S30 to %S59 109 Description of system words %SW12 to %SW18 112 Description of system words %SW48 to %SW59 Description of System Words %Sw60 to %SW63 116 Glossary 119 Index 135 6 About the book At a glance Document Scope This document describes the functions and function blocks of the System library. This document is valid for Unity pro version 2.1 Validity Note right to modity our products in line with our policy of continuous producr The data and illustrations found in this document are not binding. We reserve the development. The information in this document is subject to change without notice and should not be construed as a commitment by Schneider Electric Product Related Schneider Electric assumes no responsibility for any errors that may appear in this Warnings document. If you have any suggestions for improvements or amendments or have found errors in this publication please notify us No part of this document may be reproduced in any form or by any means, electronic or mechanical, including photocopying, without express written permission of Schneider Electric All pertinent state, regional, and local safety regulations must be observed when installing and using this product. For reasons of safety and to ensure compliance with documented system data, only the manufacturer should perform repairs to components When controllers are used for applications with technical safety requirements please follow the relevant instructions Failure to use Schneider Electric software or approved software with our hardware products may result in injury, harm, or improper operating results Failure to observe this product related warning can result in injury or equipment damage User Com ments We welcome your comments about this document. You can reach us by e-mail at TECHCOMMmodicon.com About the book General information Introduction verve This section provides general information on the System library What's This part contains the following chapters in this part? Chapter Chapter Name Page Block types and their applications 11 Availability of the function block on different hardware 19 platforms General information 10
(系统自动生成,下载前可以参看下载内容)

下载文件列表

相关说明

  • 本站资源为会员上传分享交流与学习,如有侵犯您的权益,请联系我们删除.
  • 本站是交换下载平台,提供交流渠道,下载内容来自于网络,除下载问题外,其它问题请自行百度
  • 本站已设置防盗链,请勿用迅雷、QQ旋风等多线程下载软件下载资源,下载后用WinRAR最新版进行解压.
  • 如果您发现内容无法下载,请稍后再次尝试;或者到消费记录里找到下载记录反馈给我们.
  • 下载后发现下载的内容跟说明不相乎,请到消费记录里找到下载记录反馈给我们,经确认后退回积分.
  • 如下载前有疑问,可以通过点击"提供者"的名字,查看对方的联系方式,联系对方咨询.
 输入关键字,在本站1000多万海量源码库中尽情搜索: