天水二一三CJX4-□□□Z系列直流操作交流接触器样本下载.pdf天水二一三CJX4-□□□Z系列直

文件名称: 天水二一三CJX4-□□□Z系列直流操作交流接触器样本下载.pdf

所属分类: 其它

开发工具:

文件大小: 4mb

下载次数: 0

上传时间: 2019-10-08

提供者: weixin_********

下载 (4mb)

不能下载？报告错误

详细说明：天水二一三CJX4-□□□Z系列直流操作交流接触器样本下载pdf,天水二一三电器有限云司 UL 2.5 ELEL 长城电工用途 APPLICAT|ON the dews, which would appear due to temperature change C∝X4-匚□□Z系列直流操作交流接触贔接舳赑遹用于交流5Hz{或6Hz)、额定绝缘电压至69σ、额定工作电医至 △环境污染等级为“污染等级3” Pollution grade: Grade3 安装类别为“安装类别Ⅲ"; Installation categories: class ill 660V,在AC-3使用类别下额定工作电流至32A的电力控制系统中,供接通和分断电路,并与适当的热继电器或电子式保护装置组 △该系列接触器可采用螺钉安装或安装在35mm安装轨上合成电动机动眢,以保护可能发生过载的电路。四极接触器尤其适用于三相四线俐电路中对中性线的隔离,两开两闭接触器适 he range contactor installation way: by screw or installed on 35mm type rail track 用于低感、徹感或电阳炉等负载作双电源切换之用技术参数 TECHNICAL PARAMETERS CJX4-1lZ series DC operation AC contactor is suitable for use in AC frequency 50 Hz (or 60 Hz), rated voltage to 690 V insulation, rated voltage to 660 v, in AC-3 under rated current use category to 32A power control system, and the 参数 parameters CJx4-09口2cJX4-12口zCJX4-25zCJX4-18匚z X4-32二Z oints for through broken circuit and with the appropriate thermal relay or electronic protection device combined into motor starter, to protect the possible overload circuit. Four contactor is especially suitable for three-phase four wire circuits to P+NO、3F+NC、4P、2P+2R 3P+N。、3P+NC neutral line of isolation two apen two close contact device used in low feeling tiny feeling or resistance furnace load such as 额定绝緣电压UV Hated insulation volt double switching power supply with 额定工作电庄UeV 执行标准 conform to stand ards 380660 GB14048.1-2006低压开关设和控測设备第一部分:总则 ntional thermal current 2 GB 14048.1-2006 Low pressure switch equipment and cantrol equipment the first part: general GB14048.4-2010低压开关设眢和控制设舒第一部分:接触器和电动机起动器机电式接触器和电动机起动器(含电动机额定工作电流 c Rated work current 保护器) 控制电动机功率Pe(KW) Rated cont GB 14048.4-2010 Low pressure switch equipment and control equipment the first part: contactor and motor starter 【AC-3),380V electromechanical contactor and motor starter (including motor protector) 量大操作频率h Operation frequency 1200次·h 产品型号及规格 TYPE AND CHARACTERS ■型号及含义 type and means 额定控制客量 Rated control capaci 36aA〔AC-15)33w|DC-13 CJX4-口彐匚z匚可接通最小负载册用产品代号"C"铁路用产品代号 24v 10mA 控制电 Rated control voltage Usv Dc:24V、4BV、110V、220 表示直流操作 Said Dc operation 线图功率吸合/保持表示辅助头为常开,9表示辅助触头为常闭,4表示四对常开主触头, 线圈 CJX4-09-1Bz小于11W、CJX4-25-32Z小于15W 8表示二对管开二对常闭主细头合电压 3. said auxiliary contact for a pair of regular open, 9, said assisted a pair of 0.85U8-1.1us close contact, 04, said the main contact for four pairs of regular d the main contact, 08, said the main contact for 2 pairs of regular 秤放电压 0.10Us-0,7Us irs of regular closed 在AG-3使用类别下额定工作电压为380V时的额定工作电流(A 顶装铺助鲢头组 Auxiliary contacts he use of Ac-3 category rated voltage 380V for the current rating (A) 4-220dsK4-320d 设计序号 Design serial number uxiliary parts F3-31d、F3-13 sK4-224dsK4-324d 接触器 Contactor 线根数或210r 产品特点 STRUCTURE FEATURE 25mm2 4 mm o mn ■结构特点 structure feature 作机构为直动式,触头为双断点 6 mm 10 Direct-moving and double breaking contact terminals △产品为立体布局,组合功能,顶部可加装辅助触头组及空气延时头等,有利于扩大功能外形、安装尺寸、接线图 Three-dimensional layout, modular structure, can added contact arrangement and air time-delay terminal, help to expand OUTLINE DIMENSIONS. MOUNTING DIMENSIONS. WIRING PICTURE functional △外型尺寸及安装尺寸 outline dimensions、 mounting dimensions 辅助触头设计为强制摩探结构,有自洁作用; ouble breaking point contact, mandatory friction structure, self-cleaning function 八铁心釆用螺管式结构。 Splendid structure of rail core 正常工作条件与安装方式 NORMAL WORKING CONDITION AND INSTALLATION WAY 周围空气温度-25C~+6℃; Ambient temperature:-25℃~+60c 正不超过3000m;E| evation≤3000m △最高温度为+40℃时,空气的相对湿度不超过50%,在较低温度下可允许有较高的相对湿度,在20℃可达 90%。对由于温度变化偶尔产生的凝露应采取特殊的措施。 Relative humidity is not exceeding 50% at the maximum ambient temperature +40C. With lower temperature, higher humidity would be permitted, such as, humidity is up to 90% at the ambient temperature 20C, Should give consideration to LANZHOU GREAT WALL ELECTRICAL CORPORATION LANZHOU GREAT WALL ELECTRI CAL CORPORATION 天水二一三电器有限云司 UL 2.5 ELEL 长城电工号规格外形尺寸 outline siz9(mamm) 安装尺寸 mounting size(mm Gsc1(cJX4)系列交流接触器控制直流负载的应用参照 GSC1( CJX4)Range A.C. contactor control D. C load application reference CJX4-09Z 2~75 适用兆别最大工作电流|eA) Maximum operating current 申联极数 category Series pole C.X4-18LZ 46 72-75 09/12 g0/95 X4-252 56 cJX4-32□Z 7 2 18 18 70 00 A接线图 wiring picture 513 Al LI L2 L3 NO A1 L1 L2 L3 N AI LI L2 13 L4 4875V 2 DC-1电阻 2 60 15 1 T1 T2 T3 A2 T1 T2 T3 NC 12 TI T2 T3 T4 A22R2R44 5 2 CJX4-09321232183z53z3232 CJX4-093Z/1292189225923292 CJX4-098z12822582 订货须知 ORDER REMARK 2 ■订货时须写明以下内容: n order need attention following: 接触器的全型号及名称、控制线圈的电压及订货数量 Entitle ty pe of contactor, Voltage of control coil and arder volume 例如:CJX4-253Z直流操作交流接触器DC110V,20台; 48/75V 50 Example: CJX4-253Z DC operation AC contactor, DC, 110V, 20 sets 表示为25A接舳器的主触头为三对常开,辅助簡头为一对常开,控制线医的电压为直流110V,订货数量为20台: Means need 25A contactor, main contact are three normally open, auxiliary contact is one normally open, control coil L:R≤15ms 125V 2 B roltage is DC 110v, order volume is 20 sets △特殊控制电压规格产品,如用户需要可特乘订货 For special character of control valtage praduct, should customize 2 1,5 1,5 3 5 元感或微感负载(如;电阻炉等 DC-1: Non-inductive or slightly inductive load (such as: resistance furnace, etc DC-2:并励电动机启动运转时分断电动机 DC-3:并励电动机启动、反制动与反向及点动 DC-3: The shunt motor starts, reverse braking and reverse and jog DC-4:串励电动机启动运转时分断电动机 C-5:串励甩动机启动、反接制动与反向及点动 DC-5: The series motor starts, reverse braking and reverse and jog LANZHOU GREAT WALL ELECTRICAL CORPORATION LANZHOU GREAT WALL ELECTRI CAL CORPORATION 天水二一三电器有限云司 UL 2.5 ELEL 长城电工号规格外形尺寸 outline siz9(mamm) 安装尺寸 mounting size(mm Gsc1(cJX4)系列交流接触器控制直流负载的应用参照 GSC1( CJX4)Range A.C. contactor control D. C load application reference CJX4-09Z 2~75 适用兆别最大工作电流|eA) Maximum operating current 申联极数 category Series pole C.X4-18LZ 46 72-75 09/12 g0/95 X4-252 56 cJX4-32□Z 7 2 18 18 70 00 A接线图 wiring picture 513 Al LI L2 L3 NO A1 L1 L2 L3 N AI LI L2 13 L4 4875V 2 DC-1电阻 2 60 15 1 T1 T2 T3 A2 T1 T2 T3 NC 12 TI T2 T3 T4 A22R2R44 5 2 CJX4-09321232183z53z3232 CJX4-093Z/1292189225923292 CJX4-098z12822582 订货须知 ORDER REMARK 2 ■订货时须写明以下内容: n order need attention following: 接触器的全型号及名称、控制线圈的电压及订货数量 Entitle ty pe of contactor, Voltage of control coil and arder volume 例如:CJX4-253Z直流操作交流接触器DC110V,20台; 48/75V 50 Example: CJX4-253Z DC operation AC contactor, DC, 110V, 20 sets 表示为25A接舳器的主触头为三对常开,辅助簡头为一对常开,控制线医的电压为直流110V,订货数量为20台: Means need 25A contactor, main contact are three normally open, auxiliary contact is one normally open, control coil L:R≤15ms 125V 2 B roltage is DC 110v, order volume is 20 sets △特殊控制电压规格产品,如用户需要可特乘订货 For special character of control valtage praduct, should customize 2 1,5 1,5 3 5 元感或微感负载(如;电阻炉等 DC-1: Non-inductive or slightly inductive load (such as: resistance furnace, etc DC-2:并励电动机启动运转时分断电动机 DC-3:并励电动机启动、反制动与反向及点动 DC-3: The shunt motor starts, reverse braking and reverse and jog DC-4:串励电动机启动运转时分断电动机 C-5:串励甩动机启动、反接制动与反向及点动 DC-5: The series motor starts, reverse braking and reverse and jog LANZHOU GREAT WALL ELECTRICAL CORPORATION LANZHOU GREAT WALL ELECTRI CAL CORPORATION

(系统自动生成,下载前可以参看下载内容)