台达可编程控制器（PLC）DVP-EH3安装说明.pdf台达可编程控制器（PLC）DVP-EH3安装

文件名称: 台达可编程控制器（PLC）DVP-EH3安装说明.pdf

所属分类: 其它

开发工具:

文件大小: 1003kb

下载次数: 0

上传时间: 2019-09-14

提供者: weixin_********

下载 (1003kb)

不能下载？报告错误

详细说明：台达可编程控制器（PLC）DVP-EH3安装说明pdf,台达可编程控制器（PLC）DVP-EH3安装说明Electrical Specifications Model 16EH 20EH 32EH 32EH40EH48EH64EH80EH 00口300300300M300口300300300口3 Power supply10-240Ac(15%-10%5060H+±5% e capacity 2A/250VAC Power mption 50VA 60VA 80VA DC24V current 500mA Power supplyDC24V output short circuit protection 1, 500VAC(Primary-secondary), 1, 500VAC(Primary-PE), withstand Insulation resistance 5MQ at 500VDC(between all l/0 points and grou ESD: 8KV Air Discharge Noise immunity EFT: Power Line: 2KV, Digital 10: 1KV, Analog Communication 1/O: 250V Damped-Oscillatory Wave: Power Line: 1KV, Digital 1/0: 1KV, RS: 26MH 1GHz 10V/m The diameter of grounding wire shall not be less than that of L, n terminal of Grounding the power supply. When many PLCs are in use at the same time, please make sure every PLC is properly grounded Operation: 0'C-55C(temperature), 50-95%(humidity), pollution degree 2 Storage:-25C-70C(temperature), 5-95%(humidity) Vibration/shock International standards: IEC61131-2, IEC 68-2-6(TEST FC) IEC61131-2& resistance C68-2-27( EST Ea) ight (g) R:500R:520R:652 R:710R:748R:836R:948 644 T:480T:500T:612 T:6751:688T:756T848 Spec. Two Differential 24VDC single common Items inputs(200kHz 200kHz 20kHz Normal inpu Input wiring type Change wiring from S/s to SINK or SOURCE Input voltage(±10%) 5-24VDC 24VDC Input point pedance 4.7k Ohm 3. 3k Ohm 3. 3k Ohm 4.7k Ohm 4. 7kOhm of→on|>1mA(6 >2mA(1 eve on→Of<0.4mA(2V) 0.5mA(5V) f-On<150ns<150ns<3.5us Circuit for /SIGN 37 4/ Photocoupler Figure 18] BAT. LOW indicator BAT. LOW indicator will be on when the battery is in low voltage. When this happens change the battery as soon as possible in case your program and data saved in the latched area will be lost After the power is switched off, the data in the latched area are stored in SRAM memory and its power is supplied by the battery. Therefore, when the battery is in low voltage and the power-off has been lasted for more than 1 minute, the data in the latched area will be lost. If you need to permanently save the data in the latched area in the program and device D, refer to "Flash ROM permanently saved and recover mechanism"as Permanently saved mechanism ou can use WPLSoft(Options-> PLC<=>Flash) to indicate whether to permanently store the data in the latched area in Flash ROM memory(new indicated data will replace all data previously saved in the memory Recover mechanism If the battery is in low voltage(before the power is switched off when the BAT. Low indicator is on) and the power is off for more than 1 minute, PLC will automatically store the data in the latched area in the program and device d of Flash ROM into SRAM memory next time when it is re-powered ◆ Battery Life Temperature(C) 0 50 Life(year) Accuracy(second/month)of RTC Temperature (OC F) 0/32 25/7755/131 Max inaccuracy (second)-117 緊中文■ κ本使用說眀書僅提供電氣規棓丶功能規棓丶安裝配線部份說眀·其它詳細之程式設計及指令說眀請見DνP-PLC應用技術手冊【程式縞】·選購之週邊裝置詳細說眀請見該產品隨機手冊或DVP-PLC應用技術手冊【特殊模組篇】 κ本機為開放型(○ PEN TYPE)機殼·因此使用者使用本機時·必須將之安裝於貝防塵丶防潮及免於電擊/衝擊意外之外殼配線箱內另必須貝備保護措施(如:特殊之工具或鑰匙才可打開)防止痄維護人員操作或意外衝擊本體·造成危險及損壞 κ交流輸入電源不可連接於輸λ/岀信號端·否則可能造成嚴重損壞·請在上電之前再次確認電源配線·請勿在上電時觸摸仼何端子·本體上之接地端子⑨務必正確的接地·可提高產品抗雜訊能力產品外觀尺寸與部位介紹 ④coM2(Rs-485)⑦功能卡固定孔 13功能卡插槽 ② Run/Stop開關⑧電源丶運行丶錯誤及電池狀態指示④4通訊口上蓋 O模組連接口 1功能上屁憶卡上蓋 ④coM1(Rs232)⑩機身固定螺絲 16VO模組連接卡上蓋 5電池插槽 ①1直接固定孔 ⑥電池 2記憶卡插槽詳細產品外觀及尺寸圖請參閱英文版頁碼1之[ Figure1和2]·單位:mm。 ■電氣規格機種16EH20EH32EH32EH40EH48EH64EH80EH 項目 0口300口300口300M300口3 0□300300口3 電源電壓 100~240VAc(-15%~10%);5060Hz±5% 電源保險絲容量2A/250VAC 消耗功率 50VA 60VA 80VA DC24V電流輸出500mA 電源保護 DC24∨輸出具短路保護突波電壓耐受量 1, 500VAC(Primary-secondary), 1, 500VAC(Primary-PE), 500VAC (Secondary-PE) 絕緣阻抗 5MΩ以上(所有輸出/入點對地之間500VDC) ESD: 8KV Air Discharge 雜訊免疫力 EFT: Power Line: 2KV, Digital 1/0: 1KV, Analog Communication 1/0: 250V Damped-Oscillatory Wave: Power Line: 1KV, Digital 1/O: 1KV, RS: 26MHZ 1GHz 10V/m 接地接地配線之線徑不得小於電源端L,N之線徑(多台PLC冋時使用時·請務必單點接地) 操作/儲存環境操作:0°C~55°C(溫度)·50~95%(濕度)·污染等級儲存:-25°C-70°C(溫度)·5~95%(深度) 耐振動/衝擊國際標準規範lEC611312,EC68-2-6( TEST FC)EC61131-2&EC 68-2-27( TEST Ea) R:500R:520R:652 R:710R:748R:836R:948 重量(g) 644 T:480T:500T:612 T:675T:688T:756T:848 9

(系统自动生成,下载前可以参看下载内容)